D-Link xStack DGS-3120 Series - Page 423

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
418
Format
copy {{unit <unit_id>} <drive_id>} <pathname> {{unit <unit_id>} <drive_id>} <pathname>
Parameters
unit - (Optional) Unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value. This value must be between 1 and 6.
<drive_id> - (Optional) Enter the drive ID. Examples are C: or D:
<pathname> - Specify the file to be copied. The path name can be specified either as a full path
name or partial name. For partial path name, it indicates the file is in the current directory.
unit - (Optional) Unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value. This value must be between 1 and 6.
<drive_id> - (Optional) Enter the drive ID. Examples are C: or D:
<pathname> - Specify the file to copy to. The path name can be specified either as a full path
name or partial name. For partial path name, it indicates the file is in the current directory.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To copy a file:
DGS-3120-24TC:admin# copy c:/log.txt c:/log1.txt
Command: copy c:/log.txt c:/log1.txt
Success.
DGS-3120-24TC:admin#
38-12 format
Description
This command is used to format a specific drive.
Format
format {unit <unit_id>} <drive_id> {[fat16 | fat32]} {<label_name>}
Parameters
unit - (Optional) Unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value. This value must be between 1 and 6.
<drive_id> - Specify drive to be formatted.
fat16 - Specify a FAT16 file system
fat32 - Specify a FAT32 file system
<label_name> - (Optional) Enter the label for the drive here. This value can be up to 8 characters
long.