D-Link xStack DGS-3120 Series - Page 436

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
431
DGS-3120-24TC:admin#show igmp check_subscriber_source_network
Command: show igmp check_subscriber_source_network
Interface IP Address/Netmask Check Subscriber Source Network
------------ ------------------ -------------------------
System 10.90.90.90/8 Enabled
n1 1.1.1.1/8 Disabled
n11 11.1.1.1/8 Disabled
n20 20.1.1.1/8 Disabled
n100 100.3.2.2/8 Disabled
Total Entries: 5
DGS-3120-24TC:admin#
40-6 create igmp static_group ipif
Description
This command is used to create an IGMP static group on the Switch.
Format
create igmp static_group ipif <ipif_name 12> group <multicast_ipaddr>
Parameters
<ipif_name 12> - Enter the IP interface name used for this configuration. This name can be up to
12 characters long.
group - Specify the multicast IP address used.
<multicast_ipaddr> - Enter the multicast IP address used here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an IGMP static group, with the multicast IP address 225.0.0.2 on the IP interface
“System”:
DGS-3120-24TC:admin#create igmp static_group ipif System group 225.0.0.2
Command: create igmp static_group ipif System group 225.0.0.2
Success.
DGS-3120-24TC:admin#
40-7 delete igmp static_group ipif
Description
This command is used to delete an IGMP static group on the Switch.