D-Link xStack DGS-3120 Series - Page 457

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
452
42-15 clear igmp_snooping data_driven_group (EI and SI Mode
Only)
Description
This command is used to delete the IGMP snooping group(s) learned by data driven.
Format
clear igmp_snooping data_driven_group [all | [vlan_name <vlan_name 32> | vlanid
<vlanid_list>] [<ipaddr> | all]]
Parameters
all - Specify all VLANs to which IGMP snooping groups will be deleted.
vlan_name - Specify the VLAN name.
<vlan_name 32> - Enter the VLAN name here.
vlanid - Specify the VLAN ID.
<vlanid_list> - Enter the VLAN ID here.
<ipaddr> - Specify the group’s IP address learned by data driven.
all - Delete all IGMP snooping groups of specified VLANs.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete all the groups learned by data-driven:
DGS-3120-24TC:admin# clear igmp_snooping data_driven_group all
Command: clear igmp_snooping data_driven_group all
Success.
DGS-3120-24TC:admin#
42-16 show igmp_snooping
Description
This command is used to display the current IGMP snooping configuration on the Switch.
Format
show igmp_snooping {[vlan <vlan_name 32> | vlanid <vlanid_list>]}
Parameters
vlan - (Optional) Specify the name of the VLAN for which you want to view the IGMP snooping
configuration.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.