xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
454
<vlanid_list> - Enter the VLAN ID list here.
Restrictions
None.
Example
To display the IGMP snooping rate limit for ports 1 to 5:
DGS-3120-24TC:admin#show igmp_snooping rate_limit ports 1-5
Command: show igmp_snooping rate_limit ports 1:1-1:5
Port Rate Limit(pkt/sec)
-------- --------------------
1:1 No Limit
1:2 100
1:3 No Limit
1:4 No Limit
1:5 No Limit
Total Entries: 5
42-18 show igmp_snooping group
Description
This command is used to display the current IGMP snooping group configuration on the Switch.
Format
show igmp_snooping g
roup {[vlan <vlan_
name 32> | vlanid <vlani
d_list> | ports <portli
st>]
{<ipaddr>}} {data_driven}
Parameters
vlan - (Optional) Specify the name of the VLAN for which you want to view IGMP snooping group
information. If VLAN, ports and IP address are not specified, the system will display all current
IGMP snooping group information.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
vlanid - (Optional) Specify the ID of the VLAN for which you want to view IGMP snooping group
<vlanid_list> - Enter the VLAN ID list here.
ports - (Optional) Specify a list of ports for which you want to view IGMP snooping group
<portlist> - Enter the list of ports here.
<ipaddr> - (Optional) Specify the group IP address for which you want to view IGMP snooping
group information.
data_driven - (Optional) If data_driven is specified, only data driven groups will be displayed.
(EI and SI Mode Only)
To Next Page
Loading...
Need help?
General
