D-Link xStack DGS-3120 Series - Page 471

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
466
43-3 create address_binding ip_mac ipv6address
Description
This command is used to create an IP-MAC-Port binding entry using IPv6.
Format
create address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr> {ports
[ <portlist>| all ]}
Parameters
<ipv6addr> - Specify the IPv6 address.
mac_address - Specify the MAC address.
<macaddr> - Enter the MAC address here.
ports - (Optional) Configure the portlist or all ports.
<portlist> - Specify a range of ports to be configured.
all - Specify to apply to all the ports.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a static IPv6 IMPB entry that binds the IPv6 address fe80::240:5ff:fe00:28 to the MAC
address 00-00-00-00-00-11:
DGS-3120-24TC:admin#create address_binding ip_mac ipv6address
fe80::240:5ff:fe00:28 mac_address 00-00-00-00-00-11
Command: create address_binding ip_mac ipv6address FE80::240:5FF:FE00:28
mac_address 00-00-00-00-00-11
Success.
DGS-3120-24TC:admin#
43-4 config address_binding ip_mac ipv6address
Description
This command is used to update an address binding entry using IPv6.
Format
config address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr> {ports
[<portlist>| all]}
Parameters
<ipv6addr> - Enter the IPv6 address used here.