D-Link xStack DGS-3120 Series - Page 475

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
470
Example
To show the IMPB global configuration:
DGS-3120-24TC:admin#show address_binding
Command: show address_binding
Roaming state : Enabled
Trap/Log : Disabled
DHCP Snoop(IPv4) : Disabled
DHCP Snoop(IPv6) : Disabled
ND Snoop : Disabled
Autosave state : Enabled
Save Filename : dhcpsnp.cfg
Function Version : 3.97
DGS-3120-24TC:admin#
To display the IMPB settings for ports 1 to 10:
DGS-3120-24TC:admin#show address_binding ports 1-10
Command: show address_binding ports 1-10
ARP:ARP Inspection IP:IP Inspection ND:ND Inspection Prot:Protocol
Port ARP IP ND Prot Zero IP DHCP Packet Stop Learning
Threshold/Mode
----- -------- -------- -------- ---- --------- ----------- --------------
1 Disabled Disabled Disabled All Not Allow Forward 500/Normal
2 Disabled Disabled Disabled All Not Allow Forward 500/Normal
3 Disabled Disabled Disabled All Not Allow Forward 500/Normal
4 Disabled Disabled Disabled All Not Allow Forward 500/Normal
5 Disabled Disabled Disabled All Not Allow Forward 500/Normal
6 Disabled Disabled Disabled All Not Allow Forward 500/Normal
7 Disabled Disabled Disabled All Not Allow Forward 500/Normal
8 Disabled Disabled Disabled All Not Allow Forward 500/Normal
9 Disabled Disabled Disabled All Not Allow Forward 500/Normal
10 Disabled Disabled Disabled All Not Allow Forward 500/Normal
DGS-3120-24TC:admin#
43-9 show address_binding blocked
Description
This command is used to display the blocked MAC entries.
Format
show address_binding blocked [all | vlan_name <vlan_name> mac_address <macaddr>]