D-Link xStack DGS-3120 Series - Page 474

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
469
Format
config address_binding ip_mac ipaddress <ipaddr> mac_address <macaddr> {ports
[<portlist> | all]}
Parameters
ipaddress - Specify the IP address of the entry being updated.
<ipaddr> - Enter the IP address used here.
mac_address - Specify the MAC address of the entry being updated
<macaddr> - Enter the MAC address used here.
ports - (Optional) Specify which ports are used for the IMPB entry being updated. If not specified,
then it is applied to all ports.
<portlist> - Enter the list of port used here.
all - Specify that all the ports will be used.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an IMPB entry:
DGS-3120-24TC:admin# config address_binding ip_mac ipaddress 10.1.1.1
mac_address 00-00-00-00-00-11
Command: config address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-
00-00-11
Success.
DGS-3120-24TC:admin#
43-8 show address_binding
Description
This command is used to display the IMPB global settings or IMPB settings on specified ports.
Format
show address_binding {ports {<portlist>}}
Parameters
ports - (Optional) Specify the ports for which the information is displayed. If not specified, all
ports are displayed.
<portlist> - (Optional) Enter the list of ports used here.
Restrictions
None.