xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
43
DGS-3120-24TC:admin# config 802.1x fwd_pdu system enable
Command: config 802.1x fwd_pdu system enable
Success.
4-8 config 802.1x fwd_pdu ports
Description
This command is used to control the forwarding of EAPOL PDU. When 802.1X functionality is
disabled globally or for a port, and if 802.1X fwd_pdu is enabled both globally and for the port, a
received EAPOL packet on the port will be flooded in the same VLAN to those ports for which
802.1X fwd_pdu is enabled and 802.1X is disabled (globally or just for the port). The default state
is disabled.
Format
config 802
.1x fwd_pdu ports [<por
tlist> | all] [enable | di
sable]
Parameters
<portlist> - Enter the list of ports used for the configuration.
all - Specify that all the ports will be used.
enable - Enable forwarding EAPOL PDU receive on the ports.
disable - Disable forwarding EAPOL PDU receive on the ports.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure 802.1X fwd_pdu for ports:
DGS-3120-24TC:admin#config 802.1x fwd_pdu ports 1:1-1:2 enable
Command: config 802.1x fwd_pdu ports 1:1-1:2 enable
Success.
4-9 config 802.1x authorization attributes
Description
This command is used to enable or disable acception of authorized configuration.
When the authorization is enabled for 802.1X’s RADIUS authentication, the authorized attributes
(for example VLAN, 802.1p default priority, and ACL) assigned by the RADUIS server will be
accepted if the global authorization status is enabled.
To Next Page
Loading...
Need help?
General
