xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
44
Format
config 802.1x authorization attributes radius [enable | disable]
Parameters
radius - If specified to enable, the authorization attributes (for example VLAN, 802.1p default
priority, and ACL) assigned by the RADUIS server will be accepted if the global authorization
status is enabled. The default state is enabled.
enable - Specify to enable the authorization attributes.
disable - Specify to disable the authorization attributes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
The following example will disable to accept the authorized data assigned from the RADIUS server:
DGS-3120-24TC:admin#config 802.1x authorization attributes radius disable
Command: config 802.1x authorization attributes radius disable
Success.
4-10 show 802.1x
Description
This command is used to display the 802.1X state or configurations.
Format
show 802.1x
{[auth_state | auth_c
onfiguration] por
ts {<portlist>}}
Parameters
auth_state - (Optional) Used to display 802.1X authentication state machine of some or all ports
auth_configuration - (Optional) Used to display 802.1X configurations of some or all ports.
port - (Optional) Specify a range of ports to be displayed. If no port is specified, all ports will be
<portlist> - Enter the list of ports used for the configuration here.
If no parameter is specified, the 802.1X system configurations will be displayed.
Restrictions
None.
Example
To display the 802.1X port level configurations:
To Next Page
Loading...
Need help?
General
