D-Link xStack DGS-3120 Series - Page 501

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
496
<list_name 16> - Enter the name of the IP access list.
metric - Specify to match the metric of the routes.
<uint 0-4294967294> - Enter the value of the metric.
route_type - Specify to match the type of the routes.
internal - Specify to match the AS- internal routes.
external - Specify to match the AS-external routes.
type_1 - Specify to match the AS-external type-1 routes.
type_2 - Specify to match the AS-external type-2 routes.
interface - Specify to match the first hop interface of routes.
<ipif_name 12> - Enter the name of the interface.
route_source - Specify to match the advertising source address.
<list_name 16> - Enter the IP access-list name.
set - Specify to configure the set rules.
add - Add a set rule.
delete - Delete a set rule.
next_hop - “Specify to set the next hop of the routes.
<ipaddr> - Enter the IP address of the next hop.
metric - Specify to set the metric of the routes.
<uint 0-4294967294> - Enter the value of the metric.
metric_type - Specify to set the type of metric of the routes.
type_1 - Specify to set the metric of the routes to be the OSPF external type 1
metric.
type_2 - Specify to set the metric of the routes to be the OSPF external type 2
metric.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add a sequence to the route map:
DGS-3120-24TC:admin#config route_map map1 add sequence 20
Command: config route_map map1 add sequence 20
Success.
DGS-3120-24TC:admin#
45-7 delete route_map
Description
This command is used to delete a route map configuration
Format
delete route_map [map_name <map_name 16> {all_seqence} | all]
Parameters
map_name - Specify the name of the route map.
<mep_name 16> - Enter the route map name.
all_sequence - (Optional) Specify to remove all sequence entries from the route map. The