xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
500
46-2 delete ip_tunnel
Description
This command is used to delete an IP tunnel interface.
Format
delete ip_tunnel <tunnel_name 12>
Parameters
<tunnel_name 12> - Enter the IP tunnel interface name used here. This name can be up to 12
characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IP tunnel interface (with the tunnel name “tn2”):
DGS-3120-24TC:admin#delete ip_tunnel tn2
Command: delete ip_tunnel tn2
Success.
46-3 config ip_tunnel manual
Description
This command is used to configure an IPv6 manual tunnel. If this tunnel has previously been
configured in another mode, the tunnel’s information will still exist in the database. However,
whether the tunnel’s former information is invalid or not, will depend on the current mode.
IPv6 Manual tunnels are simple point-to-point tunnels that can be used within a site or between
sites.
Format
config ip_tunnel manual <tunnel_name 12> {ipv6address <ipv6networkaddr> | source
<ipaddr> | destination <ipaddr>}(1)
Parameters
<tunnel_name 12> - Enter the IP tunnel interface name used here. This name can be up to 12
characters long.
ipv6address - (Optional) Specify the IPv6 address assigned to the IPv6 tunnel interface. IPv6
processing becomes enabled on the IPv6 tunnel interface when an IPv6 address is
configured. The IPv6 address is not connected with the tunnel source or the destination IPv4
To Next Page
Loading...
Need help?
General
