D-Link xStack DGS-3120 Series - Page 517

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
512
Example
To configure the RA state as enabled and the life_time of the “System” interface to be 1000
seconds:
DGS-3120-24TC:admin#config ipv6 nd ra ipif System state enable life_time 1000
Command: config ipv6 nd ra ipif System state enable life_time 1000
Success.
DGS-3120-24TC:admin#
47-7 config ipv6 nd ra prefix_option ipif (RI Mode Only)
Description
This command is used to configure the prefix option for the router advertisement function.
Format
config ipv6 nd ra prefix_option ipif <ipif_name 12> <ipv6networkaddr> {preferred_life_time
<sec 0-4294967295> | valid_life_time <sec 0-4294967295> | on_link_flag [enable | disable] |
autonomous_flag [enable | disable]}(1)
Parameters
<ipif_name 12> - Specify the name of the interface. The maximum length is 12 characters.
<ipv6networkaddr> - Specify the IPv6 network address.
preferred_life_time - Specify the number in milliseconds that an address, based on the specified
prefix using the stateless address configuration, remains in preferred state.
<sec 0-4294967295> - Specify the time between 0 and 4294967295 milliseconds. For an
infinite valid lifetime the value can be set to 4294967295.
valid_life_time - Specify the number of seconds that an address, based on the specified prefix,
using the stateless address configuration, remains valid.
<sec 0-4294967295> - Specify the time between 0 and 4294967295 milliseconds. For an
infinite valid lifetime the value can be set to 4294967295.
on_link_flag - Specify to enable or disable the function.
enable - Setting this field to enable will denote, within the IPv6 packet, that the IPv6 prefix
configured here is assigned to this link-local network. Once traffic has been successfully
sent to these nodes with this specific IPv6 prefix, the nodes will be considered reachable
on the link-local network.
disable - When set to disable, the addresses implied by the specified prefix are not available
on the link where the RA message is received.
autonomous_flag - Specify to enable or disable the function.
enable - Setting this field to enable will denote that this prefix may be used to autoconfigure
IPv6 addresses on the link-local network.
disable - When set to disable, the specified prefix will not be used to create an autonomous
address configuration.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.