D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
553
52-7 show lacp_port
Description
This command is used to display the current mode of LACP of the ports.
Format
show lacp_port <portlist>
Parameters
lacp_port - Specified a range of ports to be configured.
<portlist> - Enter the list of ports used for this configuration here.
If no parameter specified, the system will display current LACP and all port status.
Restrictions
None.
Example
To show port LACP mode:
DGS-3120-24TC:admin#show lacp_port
Command: show lacp_port
Port Activity
----- --------
1:1 Passive
1:2 Passive
1:3 Passive
1:4 Passive
1:5 Passive
1:6 Passive
1:7 Passive
1:8 Passive
1:9 Passive
1:10 Passive
1:11 Passive
1:12 Passive
1:13 Passive
1:14 Passive
1:15 Passive
1:16 Passive
1:17 Passive
1:18 Passive
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)