D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
564
Restrictions
None.
Example
To display the LLDP port 1 TLV option configuration:
DGS-3120-24TC:admin#show lldp ports 1:1
Command: show lldp ports 1:1
Port ID : 1:1
-----------------------------------------------------------------
Admin Status : TX_and_RX
Notification Status : Enabled
Advertised TLVs Option :
Port Description Disabled
System Name Disabled
System Description Disabled
System Capabilities Disabled
Enabled Management Address
(None)
Port VLAN ID Disabled
Enabled Port_and_Protocol_VLAN_ID
(None)
Enabled VLAN Name
(None)
Enabled Protocol_Identity
(None)
MAC/PHY Configuration/Status Disabled
Link Aggregation Disabled
Maximum Frame Size Disabled
DGS-3120-24TC:admin#
53-10 show lldp local_ports
Description
This command is used to display the per-port information currently available for populating
outbound LLDP advertisements.
Format
show lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
Parameters
<portlist> - (Optional) Specified a range of ports to be configured. When port list is not specified,
information for all ports will be displayed.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)