D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
565
mode - (Optional) Specify the display mode.
brief - Display the information in brief mode.
normal - Display the information in normal mode. This is the default display mode.
detailed - Display the information in detailed mode.
Restrictions
None.
Example
To display outbound LLDP advertisements for port 1 in detailed mode. Port description on the
display should use the same value as ifDescr.
DGS-3120-24TC:admin#show lldp local_ports 1:1 mode detailed
Command: show lldp local_ports 1:1 mode detailed
Port ID : 1:1
-----------------------------------------------------------------------------
Port ID Subtype : MAC Address
Port ID : 00-01-02-03-04-01
Port Description : D-Link DGS-3120-24TC R2.00.010
Port 1 on Unit 1
Port PVID : 1
Management Address Count : 2
Subtype : IPv4
Address : 0.0.0.0
IF Type : IfIndex
OID : 1.3.6.1.4.1.171.10.117.1.1
Subtype : IPv4
Address : 10.90.90.90
IF Type : IfIndex
OID : 1.3.6.1.4.1.171.10.117.1.1
PPVID Entries Count : 0
(None)
VLAN Name Entries Count : 1
Entry 1 :
VLAN ID : 1
VLAN Name : default
Protocol Identity Entries Count : 0
(None)
MAC/PHY Configuration/Status :
Auto-Negotiation Support : Supported
Auto-Negotiation Enabled : Enabled
Auto-Negotiation Advertised Capability : 6c01(hex)
Auto-Negotiation Operational MAU Type : 0010(hex)
Link Aggregation :
Aggregation Capability : Aggregated
Aggregation Status : Not Currently in Aggregation

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)