D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
52
DGS-3120-24TC:admin#config 802.1x guest_vlan ports 1:2-1:8 state enable
Command: config 802.1x guest_vlan ports 1:2-1:8 state enable
Warning, The ports are moved to Guest VLAN.
Success.
DGS-3120-24TC:admin#
4-20 show 802.1x guest_vlan
Description
This command is used to show the information of guest VLANs.
Format
show 802.1x guest_vlan
Parameters
None.
Restrictions
None.
Example
To show 802.1X guest VLAN on the Switch:
DGS-3120-24TC:admin#show 802.1x guest_vlan
Command: show 802.1x guest_vlan
Guest VLAN Setting
-----------------------------------------------------------
Guest VLAN : guestVLAN
Enabled Guest VLAN Ports : 1:2-1:8
DGS-3120-24TC:admin#
4-21 config 802.1x trap state
Description
This command is used to enable or disable the sending of 802.1X traps.
Format
config 802.1x trap state [enable | disable]

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)