D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
572
information for all ports will be displayed.
Restrictions
None.
Example
To display statistics information of port 1:
DGS-3120-24TC:admin# show lldp statistics ports 1:1
Command: show lldp statistics ports 1:1
Port ID: 1
------------------------------------------------------------------------
lldpStatsTxPortFramesTotal : 27
lldpStatsRxPortFramesDiscardedTotal : 0
lldpStatsRxPortFramesErrors : 0
lldpStatsRxPortFramesTotal : 27
lldpStatsRxPortTLVsDiscardedTotal : 0
lldpStatsRxPortTLVsUnrecognizedTotal : 0
lldpStatsRxPortAgeoutsTotal : 0
DGS-3120-24TC:admin#
53-14 config lldp_med fast_start repeat_count
Description
This command is used to configure the fast start repeat count. When an LLDP-MED Capabilities
TLV is detected for an MSAP identifier not associated with an existing LLDP remote system MIB,
the application layer shall start the fast start mechanism and set the ‘medFastStart’ timer to
‘medFastStartRepeatCount’ times 1. The default value is 4.
Format
config lldp_med fast_start repeat_count <value 1 - 10>
Parameters
<value 1-10> - Specify a fast start repeat count value between 1 and 10. The default value is 4.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure a LLDP-MED fast start repeat count of 5:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)