D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
573
DGS-3120-24TC:admin#config lldp_med fast_start repeat_count 5
Command: config lldp_med fast_start repeat_count 5
Success.
DGS-3120-24TC:admin#
53-15 config lldp_med log state
Description
This command is used to configure the log state of LLDP-MED events.
Format
config lldp_med log state [enable | disable]
Parameters
enable - Enable the log state for LLDP-MED events.
disable - Disable the log state for LLDP-MED events. The default is disabled.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable the log state of LLDP-MED events:
DGS-3120-24TC:admin#config lldp_med log state enable
Command: config lldp_med log state enable
Success.
DGS-3120-24TC:admin#
53-16 config lldp_med notification topo_change ports
Description
This command is used to enable or disable each port for sending topology change notification to
configured SNMP trap receiver(s) if an endpoint device is removed or moved to another port.
Format
config lldp_med notification topo_change ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Specify a range of ports to be configured.
all - Specify to set all ports in the system.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)