D-Link xStack DGS-3120 Series - Page 580

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
575
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable transmitting all capabilities on all ports:
DGS-3120-24TC:admin#config lldp_med ports all med_transmit_capabilities all
state enable
Command: config lldp_med ports all med_transmit_capabilities all state enable
Success.
DGS-3120-24TC:admin#
53-18 show lldp_med ports
Description
This command is used to display LLDP-MED per port configuration for advertisement options.
Format
show lldp_med ports {<portlist>}
Parameters
<portlist> - (Optional) Specify a range of ports to be displayed.
If a port list is not specified, information for all ports will be displayed.
Restrictions
None.
Example
To display LLDP-MED configuration information for port 1:1:
DGS-3120-24TC:admin#show lldp_med ports 1:1
Command: show lldp_med ports 1:1
Port ID : 1:1
-----------------------------------------------------------------
Topology Change Notification Status :Enabled
LLDP-MED Capabilities TLV :Enabled
LLDP-MED Network Policy TLV :Enabled
LLDP-MED Extended Power Via MDI PSE TLV :Enabled
LLDP-MED Inventory TLV :Enabled
DGS-3120-24TC:admin#