D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
576
53-19 show lldp_med
Description
This command is used to display the Switch’s general LLDP-MED configuration status.
Format
show lldp_med
Parameters
None.
Restrictions
None.
Example
To display the Switch’s general LLDP-MED configuration status:
DGS-3120-24TC:admin#show lldp_med
Command: show lldp_med
LLDP-MED System Information:
Device Class : Network Connectivity Device
Hardware Revision : B1
Firmware Revision : 3.00.501
Software Revision : 4.00.015
Serial Number : PVT93CB000001
Manufacturer Name : D-Link
Model Name : DGS-3120-24TC Gigabit Ethernet S
Asset ID :
PoE Device Type : PSE Device
PoE PSE Power Source : Primary
LLDP-MED Configuration:
Fast Start Repeat Count : 4
LLDP-MED Log State:Enabled
DGS-3120-24TC:admin#
53-20 show lldp_med local_ports
Description
This command is used to display the per-port LLDP-MED information currently available for
populating outbound LLDP-MED advertisements.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)