D-Link xStack DGS-3120 Series - Page 601

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
596
Parameters
password - In RADIUS mode, the Switch will communicate with the RADIUS server using this
password. The maximum length of the key is 16.
<password> - Enter the password used here. The default password is “default”.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the MAC-based Access Control password:
DGS-3120-24TC:admin# config mac_based_access_control password switch
Command: config mac_based_access_control password switch
Success.
DGS-3120-24TC:admin#
57-4 config mac_based_access_control password_type
Description
This command is used to chose the password type used for authentication via the RADIUS server.
Format
config mac_based_access_control password_type [manual_string | client_mac_address]
Parameters
manual_string - Use the same password for all clients to communicate with the RADIUS server.
client_mac_address - Use the client’s MAC address as the password to communicate with the
RADIUS server.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MAC-based Access Control using client’s MAC address as authentication
password:
DGS-3120-24TC:admin#config mac_based_access_control password_type
client_mac_address
Command: config mac_based_access_control password_type client_mac_address
Success.
DGS-3120-24TC:admin#