D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
606
57-15 show mac_based_access_control
Description
This command is used to display the MAC-based Access Control setting.
Format
show mac_based_access_control {ports {<portlist>}}
Parameters
ports – (Optional) Displays the MAC-based Access Control settings for a specific port or range of
ports.
<portlist> - (Optional) Enter the list of port used for this configuration here.
If no parameter is specified, the global MAC-based Access Control settings will be displayed.
Restrictions
None.
Examples
To show the MAC-based Access Control port configuration for ports 1 to 4:
DGS-3120-24TC:admin#show mac_based_access_control ports 1:1-1:4
Command: show mac_based_access_control ports 1:1-1:4
Port State Aging Time Block Time Auth Mode Max User
(min) (sec)
----- -------- ---------- --------- ---------- --------
1:1 Disabled 1440 300 Host-based 128
1:2 Disabled 1440 300 Host-based 128
1:3 Disabled 1440 300 Host-based 128
1:4 Disabled 1440 300 Host-based 128
DGS-3120-24TC:admin#
To show the MAC-based Access Control global configuration:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)