D-Link xStack DGS-3120 Series - Page 614

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
609
57-18 config mac_based_access_control max_users
Description
This command is used to configure the maximum number of authorized clients.
Format
config mac_based_access_control max_users [<value 1-1000> | no_limit]
Parameters
max_users - Specify to set the maximum number of authorized clients on the whole device.
<value 1-1000> - Enter the maximum users here. This value must be between 1 and 1000.
no_limit - Specify to not limit the maximum number of users on the system. By default, there
is no limit on the number of users.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the maximum number of users of the MAC-based Access Control system supports to
128:
DGS-3120-24TC:admin# config mac_based_access_control max_users 128
Command: config mac_based_access_control max_users 128
Success.
DGS-3120-24TC:admin#
57-19 config mac_based_access_control trap state
Description
This command is used to enable or disable sending of MAC-based Access Control traps.
Format
config mac_based_access_control trap state [enable | disable]
Parameters
enable - Enable trap for MAC-based Access Control. The trap of MAC-based Access Control will
be sent out.
disable - Disable trap for MAC-based Access Control.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.