D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
624
disable - Specify that the MLD state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MLD on the IP interface “System”:
DGS-3120-24TC:admin#config mld ipif System version 1 state enable
Command: config mld ipif System version 1 state enable
Success.
DGS-3120-24TC:admin#
61-2 show mld
Description
This command is used to display the MLD configurations on the switch.
Format
show mld {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specify the IP interface name.
<ipif_name 12> - Enter the IP interface name.
Restrictions
None.
Example
To display the MLD configurations on all interfaces::

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)