xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
646
disable - Enter disable to disable the data driven learning state.
aged_out - (Optional) Enable or disable the aging out of entries. By default, the state is disabled.
enable - Enter enable to enable the aged out option.
disable - Enter disable to disable the aged out option.
expiry_time - (Optional) Specify the data driven group lifetime, in seconds. This parameter is
valid only when aged_out is enabled.
<sec 1-65535> - Enter the expiry time value here. This value must be between 1 and 65535
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the data driven learning of an MLD snooping group on the default VLAN:
DGS-3120-24TC:admin# config mld_snooping data_driven_learning vlan_name
default state enable
Command: config mld_snooping data_driven_learning vlan_name default state
enable
Success.
63-16 config mld_snooping data_driven_learning
max_learned_entry (EI and SI Mode Only)
Description
This command is used to configure the maximum number of groups that can be learned by data
driven.
When the table is full, the system will stop the learning of the new data-driven groups. Traffic for
the new groups will be dropped.
Format
config mld_snooping data_driven_learning max_learned_entry <value 1-1024>
Parameters
max_learned_entry - Specify the maximum number of groups that can be learned by data
driven. The suggested default setting is 56. This default setting may vary depending on
project.
<value 1-1024> - Enter the maximum learned entry value here. This value must be between 1
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
To Next Page
Loading...
Need help?
General
