xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
647
Example
To set the maximum number of groups that can be learned by data driven:
DGS-3120-24TC:admin# config mld_snooping data_driven_learning max_learned_entry
50
Command: config mld_snooping data_driven_learning max_learned_entry 50
Success.
63-17 clear mld_snooping data_driven_group (EI and SI Mode Only)
Description
This command is used to delete the MLD snooping groups learned by data driven.
Format
clear mld_snooping data_driven_group [all | [vlan_name <vlan_name 32> | vlanid
<vlanid_list>] [<ipv6addr>| all]]
Parameters
all - Specify all VLANs to which IGMP snooping groups will be deleted.
vlan_name - Specify the VLAN name.
<vlan_name 32> - Enter the VLAN name here.
vlanid - Specify the VLAN ID.
<vlanid_list> - Enter the VLAN ID list here.
<ipaddr> - Specify the group’s IP address learned by data driven.
all - Specify to clear all data driven groups of the specified VLAN.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete all the groups learned by data-driven:
DGS-3120-24TC:admin# clear mld_snooping data_driven_group all
Command: clear mld_snooping data_driven_group all
Success.
63-18 show mld_snooping statistic counter
Description
This command is used to display the statistics counter for MLD protocol packets that are received
by the Switch since MLD snooping was enabled.
To Next Page
Loading...
Need help?
General
