D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
649
MLD v1 Report : 0
MLD v2 Report : 10
MLD v1 Done : 1
Total : 11
Total Entries : 1
DGS-3120-24TC:admin#
63-19 clear mld_snooping statistic counter
Description
This command is used to clear MLD snooping statistics counters.
Format
clear mld _snooping statistics counter
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear MLD snooping statistics counter:
DGS-3120-24TC:admin# clear mld_snooping statistic counter
Command: clear mld_snooping statistic counter
Success.
DGS-3120-24TC:admin#
63-20 config mld_snooping rate_limit
Description
This command is used to configure the rate limit of MLD control packets that are allowed by each
port or VLAN.
Format
config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)