D-Link xStack DGS-3120 Series - Page 655

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
650
Parameters
ports - Specify a range of ports to be configured.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list here.
<value 1-1000> - Configure the rate limit of MLD control packets that the Switch can process on
a specific port or VLAN. The rate is specified in packet per second. The packets that exceed
the limited rate will be dropped.
no_limit - Configure the rate limit of MLD control packets that the Switch can process on a
specific port or VLAN. The rate is specified in packet per second. The packets that exceed the
limited rate will be dropped. The default setting is no_limit.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MLD snooping per port rate limit:
DGS-3120-24TC:admin# config mld_snooping rate_limit ports 1:1 100
Command: config mld_snooping rate_limit ports 1:1 100
Success.
DGS-3120-24TC:admin#
63-21 show mld_snooping rate_limit
Description
This command is used to configure the rate limit of MLD control packets that are allowed by each
port.
Format
show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
Parameters
ports - Specify a list of ports.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a list of VLANs.
<vlanid_list> - Enter the VLAN ID list here.
Restrictions
None.
Example
To configure the mld_snooping per port rate_limit: