D-Link xStack DGS-3120 Series - Page 681

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
676
66-6 config mld_snooping multicast_vlan_group_profile
Description
This command is used to configure an MLD snooping multicast group profile on the Switch and
add or delete multicast addresses for the profile.
Format
config mld_snooping multicast_vlan_group_profile <profile_name 1-32> [add | delete]
<mcast_v6address_list>
Parameters
multicast_vlan_group_profile - Specify the multicast VLAN profile name. The maximum length
is 32 characters.
<profile_name 1-32> - Enter the multicast VLAN group profile name here. This name can be
up to 32 characters long.
add - Add a multicast address list to or from this multicast VLAN profile. The
<mcast_v6address_list> can be a continuous single multicast addresses, such as FF1E::1, a
multicast address range, such asFF1E::1-FF1E::2, or both of them, such as FF1E::1,
FF1E::10-FF1E::20.
delete - Delete multicast address list to or from this multicast VLAN profile. The
<mcast_v6address_list> can be a continuous single multicast addresses, such as FF1E::1, a
multicast address range, such as FF1E::1-FF1E::2, or both of them, such as FF1E::1,
FF1E::10-FF1E::20.
<mcast_v6address_list> - Enter the multicast VLAN IPv6 address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add a multicast address or range to an MLD snooping multicast VLAN profile with name “MOD”:
DGS-3120-24TC:admin# config mld_snooping multicast_vlan_group_profile MOD add
FF1E::1, FF1E::10-FF1E::20
Command: config mld _snooping multicast_vlan_group_profile MOD add FF1E::1,
FF1E::10-FF1E::20
Success.
DGS-3120-24TC:admin#
66-7 delete [igmp_snooping | mld_snooping]
multicast_vlan_group_profile
Description
This command is used to delete an IGMP snooping or MLD snooping multicast group profile on the
Switch. Specify a profile name to delete it. Specify all to remove all profiles along with the groups
that belong to that profile.