D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
720
Format
disable ospf
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable OSPF on the Switch:
DGS-3120-24TC:admin#disable ospf
Command: disable ospf
Success.
DGS-3120-24TC:admin#
70-21 show ospf
Description
This command is used to display the current OSPF information on the Switch.
Format
show ospf {[ipif <ipif_name 12> | all]}
Parameters
ipif - (Optional) Specify the IP interface name.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
all - Specify that all the IP interfaces will be displayed.
If no parameter is specified, the system will display the current OSPF state.
Restrictions
None.
Example
To display the current OSPF state:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)