D-Link xStack DGS-3120 Series - Page 726

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
721
DGS-3120-24TC:admin#show ospf
Command: show ospf
OSPF Router ID : 10.90.90.90 (Auto selected)
State : Disabled
OSPF Interface Settings
Interface IP Address Area ID State Link Metric
Status
------------ ------------------ --------------- -------- --------- ---------
System 10.90.90.90/8 0.0.0.0 Disabled Link Up 1
Total Entries : 1
OSPF Area Settings
Area ID Type Stub Import Summary LSA Stub Default Cost Translate
--------------- ------ ----------------------- ----------------- ---------
0.0.0.0 Normal None None None
Total Entries : 1
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All
70-22 show ospf lsdb
Description
This command is used to display the OSPF Link State Database (LSDB).
Format
show ospf lsdb {area <area_id> | advertise_router <ipaddr> | type [rtrlink | netlink |
summary | assummary | asextlink | nssa_ext | stub]}
Parameters
area - (Optional) Specify a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that
uniquely identifies the OSPF area in the OSPF domain.
<area_id> - Enter the area ID used here.
advertise_router - (Optional) Specify the IP address of the advertising router.
<ipaddr> - Enter the advertising router's IP address here.
type - (Optional) Specify the type of link displayed.
rtrlink - Specify the type to be displayed as router link.
netlink - Specify the type to be displayed as network link.
summary - Specify the type to be displayed as summary.
assummary - Specify the type to be displayed as AS summary.
asextlink - Specify the type to be displayed as AS external link.
nssa_ext - Specify the type to be displayed as NSSA external information.
stub - Specify the type to be displayed as STUB link.