D-Link xStack DGS-3120 Series - Page 727

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
722
Restrictions
None.
Example
To display the link state database of OSPF:
DGS-3120-24TC:admin#show ospf lsdb
Command: show ospf lsdb
Area LSDB Advertising Link State Cost Sequence
ID Type Router ID ID Number
--------------- --------- --------------- ----------------- -------- ---------
0.0.0.0 RTRLink 50.48.75.73 50.48.75.73 * 0x80000002
0.0.0.0 Summary 50.48.75.73 10.0.0.0/8 1 0x80000001
1.0.0.0 RTRLink 50.48.75.73 50.48.75.73 * 0x80000001
1.0.0.0 Summary 50.48.75.73 40.0.0.0/8 1 0x80000001
1.0.0.0 Summary 50.48.75.73 50.0.0.0/8 1 0x80000001
0.0.0.0 ASExtLink 50.48.75.73 1.2.0.0/16 20 0x80000001
Total Entries : 6
DGS-3120-24TC:admin#
70-23 show ospf neighbor
Description
This command is used to display the OSPF-neighbor information on a per-interface basis.
Format
show ospf neighbor {<ipaddr>}
Parameters
<ipaddr> - (Optional) Specify the IP address of the neighbor router.
If no parameter is specified, the system will display all OSPF neighbor information.
Restrictions
None.
Example
To display OSPF neighbor information: