D-Link xStack DGS-3120 Series - Page 737

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
732
Parameters
<area_id> - (Optional) Enter the OSPFv3 area ID. It is a 32-bit number in the form of an IPv4
address that uniquely identifies the OSPFv3 area in the OSPFv3 domain.
Restrictions
None.
Example
To display OSPFv3 areas:
DGS-3120-24TC:admin#show ospfv3 area
Command: show ospfv3 area
OSPFv3 Area Settings
Area ID Type Stub Import Summary LSA Stub Default Cost
--------------- ------ ----------------------- -----------------
0.0.0.0 Normal None None
1.1.1.1 Normal None None
Total Entries: 2
DGS-3120-24TC:admin#
71-10 create ospfv3 aggregation
Description
This command is used to create an OSPFv3 area aggregation.
Format
create ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
Parameters
<area_id> - Enter the OSPFv3 area ID where the aggregation belongs to.
<ipv6networkaddr> - Enter the IPv6 network address of the aggregation.
advertise - Specify whether to use this aggregation to aggregate the intra-area routes when it
advertises these routes to another area.
enable - OSPFv3 ABR(Area Border Router) will use this aggregation to aggregate the intra-
area routes when it advertises these routes to another area.
disable - OSPFv3 ABR will not use this aggregation to aggregate the intra-area routes when it
advertises these routes to another area.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.