D-Link xStack DGS-3120 Series - Page 738

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
733
Example
To create an OSPFv3 area aggregation:
DGS-3120-24TC:admin#create ospfv3 aggregation 2.2.2.2 2000::/16 advertise
enable
Command: create ospfv3 aggregation 2.2.2.2 2000::/16 advertise enable
Success.
DGS-3120-24TC:admin#
71-11 config ospfv3 aggregation
Description
This command is used to configure an OSPFv3 area aggregation.
Format
config ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
Parameters
<area_id> - Enter the OSPFv3 area ID where the aggregation belongs to.
<ipv6networkaddr> - Enter the IPv6 network address of the aggregation.
advertise - Specify whether to use this aggregation to aggregate the intra-area routes when it
advertises these routes to another area.
enable - OSPFv3 ABR(Area Border Router) will use this aggregation to aggregate the intra-
area routes when it advertises these routes to another area.
disable - OSPFv3 ABR will not use this aggregation to aggregate the intra-area routes when it
advertises these routes to another area.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure an OSPFv3 area aggregation:
DGS-3120-24TC:admin#config ospfv3 aggregation 2.2.2.2 2000::/16 advertise
disable
Command: config ospfv3 aggregation 2.2.2.2 2000::/16 advertise disable
Success.
DGS-3120-24TC:admin#
71-12 delete ospfv3 aggregation
Description
This command is used to delete an OSPFv3 area aggregation.