D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
740
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an OSPFv3 virtual link:
DGS-3120-24TC:admin#delete ospfv3 virtual_link 1.1.1.1 60.60.60.60
Command: delete ospfv3 virtual_link 1.1.1.1 60.60.60.60
Success.
DGS-3120-24TC:admin#
71-20 show ospfv3 virtual_link
Description
This command is used to display OSPFv3 virtual link configurations.
Format
show ospfv3 virtual_link {<area_id> <neighbor_id>}
Parameters
<area_id> - (Optional) Specify a 32-bit number in the form of an IPv4 address that uniquely
identifies the OSPFv3 area in the OSPFv3 domain. This area is the transit area where the
virtual link is built.
<neighbor_id> - (Optional) Specify a 32-bit number in the form of an IPv4 address that uniquely
identifies the OSPFv3 virtual neighbor in the OSPFv3 domain.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To display an OSPFv3 virtual link:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)