xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
741
DGS-3120-24TC:admin#show ospfv3 virtual_link
Command: show ospfv3 virtual_link
Virtual Interface Configuration
Transit Virtual Hello Dead Instance ID Link
Area ID Neighbor Router Interval Interval Status
--------------- --------------- -------- -------- ----------- ------
1.1.1.1 60.60.60.60 20 80 1 Down
Total Entries: 1
71-21 create ipv6route redistribute dst ospfv3 src
Description
This command is used to create a new IPv6 route redistribution to import route of other protocol
into OSPFv3.
Format
create ipv6route redistribute dst ospfv3 src [local | static | ripng] {mettype [1 | 2] | metric
<value 1-16777214>}
Parameters
local - Redistribute local routes into OSPFv3.
static - Redistribute static routes into OSPFv3.
ripng - Redistribute RIPng routes into OSPFv3.
mettype - (Optional) Allow the selection of one of two methods for calculating the metric value.
1 - 1 calculates the metric (for other routing protocols to OSPFv3) by adding the destination’s
interface cost to the metric entered in the Metric field.
2 - 2 uses the metric entered in the Metric field without change. If the metric type is not
specified, it will be type 2.
metric - (Optional) Specify the metric for the redistributed routes.
<value 1-16777214> - Enter the value between 1 and 16777214. The default value is 20.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create OSPFv3 route redistribution:
To Next Page
Loading...
