D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
797
80-17 show pim rpset
Description
This command is used to list all the RPset information.
Format
show pim rpset
Parameters
None.
Restrictions
None.
Example
To list all the RPset information:
DGS-3120-24TC:admin#show pim rpset
Command: show pim rpset
PIM RP-Set Table
Bootstrap Router: 10.54.71.9
Group Address RP Address Holdtime Expired Time Type
------------------ ------------------ --------- ------------ ------
224.0.0.0/4 10.20.6.36 210 196 Dynamic
224.0.0.0/4 10.54.71.9 0 0 Static
Total Entries: 2
DGS-3120-24TC:admin#
80-18 create pim register_checksum_include_data rp_address
Description
This command is used to decide the checksum in register packet will include the data portion or
not. As defined in RFC 4601, the checksum for Registers is done only on the first 8 bytes of the
packet, including the PIM header and the next 4 bytes, excluding the data packet portion. Some
earlier PIM-SM routers will calculate checksum for register packet including data portion. This
configuration makes our routers communicate with those earlier routers smoothly. The default set
is not including data portion.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)