D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
798
Format
create pim register_checksum_include_data rp_address <ipaddr>
Parameters
<ipaddr> - Specify that the RP will expect to receive a register packet in which the checksum will
be included in the data portion.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an entry for a specific RP in which the checksum in the registered packet will include the
data portion:
DGS-3120-24TC:admin#create pim register_checksum_include_data rp_address
24.1.2.3
Command: create pim register_checksum_include_data rp_address 24.1.2.3
Success.
DGS-3120-24TC:admin#
80-19 delete pim register_checksum_include_data rp_address
Description
This command is used to delete the register checksum including the data for the specific RP
address.
Format
delete pim register_checksum_include_data rp_address <ipaddr>
Parameters
<ipaddr> - Specify the RP address that will be removed from the checksum, including the data
portion list.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete the register checksum including the data for the specific RP address:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)