D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
804
81-2 show pim6
Description
This command is used to display the PIM6 configurations.
Format
show pim6 {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specify to the IP interface name to be displayed.
<ipif_name 12> - Enter the IP interface name.
Restrictions
None.
Example
To show brief information for the PIM6 protocol related parameters on all interfaces:
DGS-3120-24TC:admin#show pim6
Command: show pim6
PIM6 Global State : Disabled
Last Hop SPT Switchover : Never
Register Probe Interval : 5 sec
Register Suppression Timeout : 60 sec
Keepalive Period : 210 sec
Register Checksum Calculate : Not Include Data
Embedded RP State : Disabled
PIM6-SM Interface Table
DR Hello J/P BSR
Interface Priority Interval Interval State Border
------------ ---------- -------- -------- -------- --------
System 1 60 60 Enabled Disabled
Total Entries : 1
DGS-3120-24TC:admin#
To show detailed information for PIM6 protocol related parameters on the interface “System”:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)