D-Link xStack DGS-3120 Series - Page 810

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
805
DGS-3120-24TC:admin#show pim6 ipif System
Command: show pim6 ipif System
Interface name : System
Interface Link-Local Address : -
Interface Global Address : -
PIM6 Mode : SM
State : Enabled
Designated Router : -
Designated Router Priority : 1
Designated Router Priority Enabled : True
Hello Interval : 60 sec
Triggered Hello Interval : 5 sec
Hello Holdtime : 210 sec
Join Prune Interval : 60 sec
Join Prune Holdtime : 210 sec
LAN Delay Enabled : True
Propagation Delay : 1 sec
Override Interval : 3 sec
Effective Propagation Delay : 1 sec
Effective Override Interval : 3 sec
Join Suppression Enabled : False
Bidirectional Capable : False
BSR Domain Border : Disabled
Stub interface : Disabled
DGS-3120-24TC:admin#
81-3 config pim6 cbsr
Description
This command is used to set the C-BSR state, the priority and the hash mask length of the
candidate bootstrap router on an interface.
Format
config pim6 cbsr {ipif <ipif_name 12> state [enable | disable] | priority <value 0-255> |
hash_masklen <value 0-128>}(1)
Parameters
ipif - Specify the IP interface.
<ipif_name 12> - Enter the IP interface name. This name can be up to 12 characters long.
state - Specify to determine whether the input interface can be a C-BSR.
enable - Specify that the interface is a C-BSR.
disable - Specify that the interface is not a C-BSR. This is the default.
priority - (Optional) Specify to set the C-BSR priority.
<value 0-255> - Enter the value between 0 and 255. The default value is 64.
hash_masklen - Specify the length in bits of the mask. This makes use of a hash function for the
case where a group range has multiple RPs with the same priority.
<value 0-128> - Enter the value must be between 0 and 128. The default value is 126