D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
820
Parameters
<sec 3-655535> - Enter the period during which a PIM DR stops sending Register-encapsulated
data to the RP after receiving a Register-Stop message. The default value is 60.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the PIM6-SM register suppression time to be 120 seconds:
DGS-3120-24TC:admin#config pim6 register_suppression_time 120
Command: config pim6 register_suppression_time 120
Success.
DGS-3120-24TC:admin#
81-24 config pim6 keepalive_period
Description
This command is used to configure the PIM6-SM multicast routing entry Keepalive Timer.
Format
config pim6 keepalive_period <sec 120-65535>
Parameters
<sec 120-655535> - Enter the period during which the PIM router will maintain the (S, G) state in
the absence of explicit (S, G) local membership or (S, G) join messages received to maintain
it. The default value is 210.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the multicast routing keepalive period to be 220 seconds:
DGS-3120-24TC:admin#config pim6 keepalive_period 220
Command: config pim6 keepalive_period 220
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)