D-Link xStack DGS-3120 Series - Page 824

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
819
Example
To specify the switch calculates the register packet checksum including the data portion:
DGS-3120-24TC:admin#config pim6 register_checksum_calculate include_data
Command: config pim6 register_checksum_calculate include_data
Success.
DGS-3120-24TC:admin#
81-22 config pim6 register_probe_time
Description
This command is used to configure the PIM6-SM register probe time.
Format
config pim6 register_probe_time <sec 1-127>
Parameters
<sec 1-127> - Enter the time before the Register-Stop Timer (RST) expires when a DR may send
a Null-Register to the RP to cause it to resend a Register-Stop message. The default value is
5.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the register probe time to be 20 seconds:
DGS-3120-24TC:admin#config pim6 register_probe_time 20
Command: config pim6 register_probe_time 20
Success.
DGS-3120-24TC:admin#
81-23 config pim6 register_suppression_time
Description
This command is used to configure the PIM6-SM register suppression time.
Format
config pim6 register_suppression_time <sec 3-65535>