D-Link xStack DGS-3120 Series - Page 823

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
818
Restrictions
None.
Example
To show all the active RP information:
DGS-3120-24TC:admin#show pim6 rpset
Command: show pim6 rpset
Bootstrap Router: 3120::110
PIM6 RP-Set Table
---------------------------------------------
Group : FF3D::/64
RP Address : 3121::110
Hold Time : 210 sec
Expired Time : 196 sec
Type : Dynamic
Group : FF3E::/64
RP Address : 3127::111
Override Dynamic : False
Type : Static
Total Entries: 2
DGS-3120-24TC:admin#
81-21 config pim6 register_checksum_calculate
Description
This command is used to decide whether the checksum in register packet will include the data
portion.
Format
config pim6 register_checksum_calculate [include_data | not_include_data]
Parameters
include_data - When specified to calculate the checksum in IPv6 PIM register packets, the data
portion is included.
not_include_data - When specified to calculate the checksum in IPv6 PIM register packets, the
data portion is excluded.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.