D-Link xStack DGS-3120 Series - Page 873

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
868
Example
To configure the RIPng method as poison reverse:
DGS-3120-24TC:admin#config ripng method poison_reverse
Command: config ripng method poison_reverse
Success.
DGS-3120-24TC:admin#
88-4 config ripng ipif
Description
This command is used to specify the RIPng state or metric value for one or all interfaces.
Format
config ripng ipif [<ipif_name 12> | all] {state [enable | disable] | metric <value 1-15>}(1)
Parameters
<ipif_name 12> - Specify the interface name.
all - Specify all interfaces to be configured.
state - Specify the RIPng state on the selected interfaces.
enable - Specify to enable the RIPng state.
disable - Specify to disable the RIPng state.
metric - The cost value of an interface. The RIPng route that was learned from the interface will
add this value as a new route metric. The default value is 1.
<value 1-15> - Enter the value between 1 and 15.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the RIPng interface state:
DGS-3120-24TC:admin#config ripng ipif System state enable
Command: config ripng ipif System state enable
Success.
DGS-3120-24TC:admin#
88-5 show ripng
Description
This command is used to display RIPng configurations.