D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
869
Format
show ripng {ipif <ipif_name 12>}
Parameters
ipif - (Optional) Specify the interface name.
<ipif_name 12> - Enter the interface name.
Restrictions
None.
Example
To display RIPng information:
DGS-3120-24TC:admin#show ripng
Command: show ripng
Global State: Enabled
Method: Poison Reverse
Update Time: 30 seconds
Expire Time: 180 seconds
Garbage Collection Time: 120 seconds
Interface State Metric
-----------------------------------------------------
int8 Disabled 1
int14 Disabled 1
Total Entries : 2
IPv6 Route Redistribution Settings
Source Destination Type Metric
Protocol Protocol
-------- ------------ -------- ------------
Local RIPng All 6
Static RIPng All Transparency
Total Entries: 2
DGS-3120-24TC:admin#
88-6 create ipv6route redistribute dst ripng src
Description
This command is used to create RIPng route redistribution to import routes from other routing
domain into RIPng routing domain.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)