D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
870
Format
create ipv6route redistribute dst ripng src [local | static | ospfv3] {metric <value 0-16>}
Parameters
local - Redistribute local routes into RIPng.
static - Redistribute static routes into RIPng.
ospfv3 - Redistribute OSPFv3 routes into RIPng.
metric - (Optional) Specify the RIPng route metric for the redistributed routes. When the metric
value is 0, the metric in the original route will become the metric of the redistributed RIPng
route transparently. If the metric of the original route is equal or greater than 16, the route will
be not redistributed.
<value 0-16> - Enter the value between 0 and 16.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create RIPng route redistribution:
DGS-3120-24TC:admin#create ipv6route redistribute dst ripng src local
Command: create ipv6route redistribute dst ripng src local
Success.
DGS-3120-24TC:admin#
88-7 config ipv6route redistribute dst ripng src
Description
This command is used to configure the metric to be associated with the redistributed routes
imported from a specified protocol to RIPng protocol.
Format
config ipv6route redistribute dst ripng src [local | static | ospfv3] {metric <value 0-16>}
Parameters
local - Redistribute local routes into RIPng.
static - Redistribute static routes into RIPng.
ospfv3 - Redistribute OSPFv3 routes into RIPng.
metric - (Optional) Specify the RIPng route metric for the redistributed routes. When the metric
value is 0, the metric in the original route will become the metric of the redistributed RIPng
route transparently. If the metric of the original route is equal or greater than 16, the route will
be not redistributed.
<value 0-16> - Enter the value between 0 and 16.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)