D-Link xStack DGS-3120 Series - Page 90

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
85
Parameters
<string 15> - Specify the user-defined server group name.
Restrictions
Only Administrator-level users can issue this command.
Example
To create a user-defined AAA server group called “mix_1”:
DGS-3120-24TC:admin#create aaa server_group mix_1
Command: create aaa server_group mix_1
Success.
DGS-3120-24TC:admin#
5-32 config aaa server_group
Description
This command is used to add or remove an AAA server host to or from the specified server group.
The built-in TACACS, XTACACS, TACACS+, and RADIUS server groups only accept server hosts
with the same protocol, but a user-defined server group can accept server hosts with different
protocols.
Format
config aaa server_group [tacacs | xtacacs | tacacs+ | radius | group_name <string 15>] [add
| delete] server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+| radius]
Parameters
tacacs - Specify the built-in TACACS server group.
xtacacs - Specify the built-in XTACACS server group.
tacacs+ - Specify the built-in TACACS+ server group.
radius - Specify the built-in RADIUS server group.
group_name - Specify a user-defined server group.
<string 15> - Enter the name of the server group.
add - Add a server host to the server group.
delete - Remove a server host to the server group.
server_host - Specify the server host.
<ipaddr> - Enter the IP address of the server host.
protocol - Specify the server host protocol.
tacacs - Specify the server host using TACACS protocol.
xtacacs - Specify the server host using XTACACS protocol.
tacacs+ - Specify the server host using TACACS+ protocol.
radius - Specify the server host using RADIUS protocol.
Restrictions
Only Administrator-level users can issue this command.