D-Link xStack DGS-3120 Series - Page 903

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
898
Example
To display all the executive schedules:
DGS-3120-24TC:admin#show execute_config
Command: show execute_config
Time Range : range-1
Filename : c:/vlan-config
Method : Reset
State : Enabled
Total Entries1
DGS-3120-24TC:admin#
92-9 execute config
Description
This command is used to execute configuration on file system.
Format
execute config <pathname> {increment}
Parameters
<pathname> - The configuration filename on file system.
increment - (Optional) If not specified, the current configuration will be reset before executing the
configuration.If specified, the current configuration will not be reset before executing the
configuration.
Restrictions
Only Administrator-level users can issue this command.
Example
To load and execute a configuration:
DGS-3120-24PC:admin#execute config c:/config-vlan-0.cfg
Command: execute config c:/config-vlan-0.cfg
Success.
DGS-3120-24TC:admin#