D-Link xStack DGS-3120 Series - Page 944

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
939
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the aging time of the surveillance VLAN to 60 minutes:
DGS-3120-24TC:admin#config surveillance_vlan aging_time 60
Command: config surveillance_vlan aging_time 60
Success.
DGS-3120-24TC:admin#
97-7 config surveillance_vlan log state
Description
This command is used to configure the log state of the surveillance VLAN.
Format
config surveillance_vlan log state [enable | disable]
Parameters
enable - Specify to enable the log state of the surveillance VLAN.
disable - Specify to disable the log state of the surveillance VLAN.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the log state of the surveillance VLAN:
DGS-3120-24TC:admin#config surveillance_vlan log state enable
Command: config surveillance_vlan log state enable
Success.
DGS-3120-24TC:admin#
97-8 show surveillance_vlan
Description
This command is used to display the surveillance VLAN information.