D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
979
Restrictions
None.
Example
To show SNMP engine ID:
DGS-3120-24TC:admin# show snmp engineID
Command: show snmp engineID
SNMP Engine ID : 1023457890
DGS-3120-24TC:admin#
101-23 config snmp system_name
Description
This command is used to configure the name for the Switch.
Format
config snmp system_name {<sw_name>}
Parameters
system_name - A maximum of 128 characters is allowed. And NULL string is accepted.
<sw_name> - (Optional) Enter the system name used here.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the Switch name for “DGS-XXXXS Stackable Switch”:
DGS-3120-24TC:admin# config snmp system_name DGS-XXXXS Stackable Switch
Command: config snmp system_name DGS-XXXXS Stackable Switch
Success.
DGS-3120-24TC:admin#
101-24 config snmp system_location
Description
This command is used to enter a description of the location of the Switch.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)